« previous next »
Pages: 1 [2]   Go Down

Author Topic: OK, how do I get out of this one?  (Read 11715 times)

Offline Rich

  • Sr. Member
  • ****
  • Posts: 284
Re: OK, how do I get out of this one?
« Reply #25 on: May 20, 2009, 11:19:07 PM »
The easiest way I've found to cut piano wire is with a cut-off wheel on the ever popular dremel tool. I also use the wheel to taper the entry end of the pin and round it.
Logged

Offline Jim Filipski

  • Hero Member
  • *****
  • Posts: 642
    • Jim W. Filipski Flintlocks
Re: OK, how do I get out of this one?
« Reply #26 on: May 20, 2009, 11:44:43 PM »
I have always used drill rod stock from brownells. If I drill with a # 49 drill bit a piece of #49 drill rod fits smoothly without binding. It is easy to cut and shape the ends ( it is unhardened as it comes) once I get them sized I harden them.
I usually buy sizes 50 ,49 & 48. They seem to work for all my pinning
Jim
Logged
" Associate with men of good quality,  if you esteem your own reputation:
for it is better to be alone than in bad company. "      -   George Washington

"A brush of the hand
of Providence is behind what is done with good heart."

Offline rich pierce

  • Administrator
  • Hero Member
  • *
  • Posts: 19524
Re: OK, how do I get out of this one?
« Reply #27 on: May 21, 2009, 01:22:13 AM »
Did we ever get a progress report?
Logged
Andover, Vermont

Offline Curt Larsen

  • Hero Member
  • *****
  • Posts: 617
Re: OK, how do I get out of this one?
« Reply #28 on: May 21, 2009, 04:04:28 AM »
Well, it did come out without any hassle.  Next time I'll try to add to the tang if it isn't long enough.  That way it will go in the lock cavity.  Still all these tips are great, so thanks.  That is what I like about this site.  We all get more ideas than we count on.

Curt
Logged
Pages: 1 [2]   Go Up
« previous next »