« previous next »
Pages: [1]   Go Down

Author Topic: Applied Tip Horn/W Screw-in Base  (Read 1090 times)

Offline Tim Crosby

  • Administrator
  • Hero Member
  • *
  • Posts: 18385
  • AKA TimBuckII
Applied Tip Horn/W Screw-in Base
« on: March 28, 2019, 08:57:21 PM »
 Another one after a horn in Jay Hopkins' book Bone Tipped & Banded Horns This one from page 282. It was found with a Simon Lauck rifle.
 It is 12" around the outside curve, 9 1/2 tip-to-tip. The Walnut base has a maple finial threaded into it that then fits into the recessed threaded Oak base, the threads are 1 X 6, it is held in place with 4 wooden pegs. The horn tip is held in place with three iron pins. The Two bands are held in place with three each. The original horn only had one band on it but there was a ghost ring where another had been so I added it.
The surface has been scraped and Saddle tan dye added followed by Brown shoe polish

  Tim C.









« Last Edit: March 28, 2019, 09:00:28 PM by Tim Crosby »
Logged

Offline Marcruger

  • Hero Member
  • *****
  • Posts: 3702
Re: Applied Tip Horn/W Screw-in Base
« Reply #1 on: March 28, 2019, 09:04:06 PM »
Oh wow. I really like the way that base unscrews. The thin side profile of the butt gives a unique look too. I think that one will sell fast Tim. God bless, Marc
Logged

Offline hanshi

  • Hero Member
  • *****
  • Posts: 5335
  • My passion is longrifles!
    • martialartsusa.com
Re: Applied Tip Horn/W Screw-in Base
« Reply #2 on: March 28, 2019, 10:57:30 PM »
I really like that horn!
Logged
!Jozai Senjo! "always present on the battlefield"
Young guys should hang out with old guys; old guys know stuff.

Offline Greg Pennell

  • Hero Member
  • *****
  • Posts: 1523
Re: Applied Tip Horn/W Screw-in Base
« Reply #3 on: March 29, 2019, 06:50:13 AM »
Another beauty! 

Greg
Logged
“Let your gun therefore be the constant companion of your walks” Thomas Jefferson

Offline aaronc

  • Hero Member
  • *****
  • Posts: 793
Re: Applied Tip Horn/W Screw-in Base
« Reply #4 on: March 29, 2019, 07:37:38 PM »
Great looking horn.
Logged
- Aaron C
At the work bench.

Offline Mark Elliott

  • Hero Member
  • *****
  • Posts: 5191
    • Mark Elliott Artist & Craftsman
Re: Applied Tip Horn/W Screw-in Base
« Reply #5 on: March 30, 2019, 01:14:04 AM »
That's some pretty good turning.
Logged

Offline Tim Crosby

  • Administrator
  • Hero Member
  • *
  • Posts: 18385
  • AKA TimBuckII
Re: Applied Tip Horn/W Screw-in Base
« Reply #6 on: March 31, 2019, 03:37:41 PM »
 Thanks for the positive comments Guys.

   Tim
Logged
Pages: [1]   Go Up
« previous next »