Author Topic: Did a little carving today...  (Read 1180 times)

Offline looper

  • Full Member
  • ***
  • Posts: 139
Did a little carving today...
« on: August 14, 2019, 06:01:12 AM »
I braved the 100 degree heat today to inlet a Colerain 42" A weight into a nice piece of hard maple today. A couple of hours and a gallon of water later...




Offline BOB HILL

  • Hero Member
  • *****
  • Posts: 2223
Re: Did a little carving today...
« Reply #1 on: August 14, 2019, 01:45:29 PM »
Looking good, Looper. You’re sure right about the heat. We’ve been working on kitchen cabinets this week. PM sent.
Bob
South Carolina Lowcountry

Offline Dan Fruth

  • Hero Member
  • *****
  • Posts: 552
    • D Fruth Flintlocker
Re: Did a little carving today...
« Reply #2 on: August 14, 2019, 03:10:09 PM »
Hey Looper, Is that a Don Allen machine, or one you built?
The old Quaker, "We are non-resistance friend, but ye are standing where I intend to shoot!"

Offline looper

  • Full Member
  • ***
  • Posts: 139
Re: Did a little carving today...
« Reply #3 on: August 14, 2019, 03:25:47 PM »
It’s a Don Allen.

Offline hanshi

  • Hero Member
  • *****
  • Posts: 5310
  • My passion is longrifles!
    • martialartsusa.com
Re: Did a little carving today...
« Reply #4 on: August 14, 2019, 09:02:48 PM »
So far, very good work!
!Jozai Senjo! "always present on the battlefield"
Young guys should hang out with old guys; old guys know stuff.