« previous next »
Pages: 1 [2]   Go Down

Author Topic: Back to Lehigh again  (Read 4048 times)

Offline J. Talbert

  • Hero Member
  • *****
  • Posts: 2309
Re: Back to Lehigh again
« Reply #25 on: April 08, 2020, 06:03:56 PM »
Mike,
I'm anxious to see how your pattern adaptations work out.  I've got a couple patterns from Allen Martin but haven't settled on which one to use for my next project.
I'm also curious to hear your assesment of the cast box.  I wonder if it will be more difficult to contour to the stock.  I presume the hinge will be fairly rigid. 
Please let us know.

Thanks
Jeff
Logged
There are no solutions.  There are only trade-offs.”
Thomas Sowell

Offline smallpatch

  • Hero Member
  • *****
  • Posts: 4107
  • Dane Lund
Re: Back to Lehigh again
« Reply #26 on: April 08, 2020, 07:19:06 PM »
J.
My Little Lehigh was built using a blank I got from Al, with the Herman Rupp profile, if you want to check it out.
Logged
In His grip,

Dane

Offline Mike Brooks

  • Hero Member
  • *****
  • Posts: 13415
    • Mike Brooks Gunmaker
Re: Back to Lehigh again
« Reply #27 on: April 09, 2020, 12:58:10 AM »
Quote from: J. Talbert on April 08, 2020, 06:03:56 PM
Mike,
I'm anxious to see how your pattern adaptations work out.  I've got a couple patterns from Allen Martin but haven't settled on which one to use for my next project.
I'm also curious to hear your assesment of the cast box.  I wonder if it will be more difficult to contour to the stock.  I presume the hinge will be fairly rigid. 
Please let us know.

Thanks
Jeff
After that box get's it's hinge pin drilled through and the knuckles fit it IS going to take a bend. :P
Logged
NEW WEBSITE! www.mikebrooksflintlocks.com
Say, any of you boys smithies? Or, if not smithies per se, were you otherwise trained in the metallurgic arts before straitened circumstances forced you into a life of aimless wanderin'?
Pages: 1 [2]   Go Up
« previous next »