« previous next »
Pages: [1]   Go Down

Author Topic: Use of Bone Black to Age a Stock  (Read 2029 times)

Offline canadianml1

  • Full Member
  • ***
  • Posts: 227
Use of Bone Black to Age a Stock
« on: June 22, 2020, 10:40:13 PM »
Any pointers for use of bone black and where to apply it to best effect would be appreciated. Thanks
Logged

Offline Mike Brooks

  • Hero Member
  • *****
  • Posts: 13415
    • Mike Brooks Gunmaker
Re: Use of Bone Black to Age a Stock
« Reply #1 on: June 22, 2020, 11:28:40 PM »
Kibler has a video, check it out.
Logged
NEW WEBSITE! www.mikebrooksflintlocks.com
Say, any of you boys smithies? Or, if not smithies per se, were you otherwise trained in the metallurgic arts before straitened circumstances forced you into a life of aimless wanderin'?

Offline deepcreekdale

  • Hero Member
  • *****
  • Posts: 641
Re: Use of Bone Black to Age a Stock
« Reply #2 on: June 28, 2020, 06:54:12 PM »
Go slow, add a little at a time to each coat of finish. It is not a one coat process. It is fun to do and can make a nice looking finish. It is not for every project though. Mike is correct, Kiblers video will help you out.
Logged
”Far and away the best prize that life has to offer is the chance to work hard at work worth doing.” Theodore Roosevelt

Offline Hungry Horse

  • Hero Member
  • *****
  • Posts: 5565
Re: Use of Bone Black to Age a Stock
« Reply #3 on: June 28, 2020, 10:16:30 PM »
 Less is definitely more with bone black. A lot of rubbing, and manipulating, is better than slathering a load of material on, and then trying to work with it. To much black and your gun looks like it went through a house fire.

  Hungry Horse
Logged

Offline Frank

  • Hero Member
  • *****
  • Posts: 968
Re: Use of Bone Black to Age a Stock
« Reply #4 on: June 28, 2020, 10:20:30 PM »
Logged

Offline Mike Brooks

  • Hero Member
  • *****
  • Posts: 13415
    • Mike Brooks Gunmaker
Re: Use of Bone Black to Age a Stock
« Reply #5 on: June 29, 2020, 01:55:18 AM »
Quote from: Hungry Horse on June 28, 2020, 10:16:30 PM
Less is definitely more with bone black. A lot of rubbing, and manipulating, is better than slathering a load of material on, and then trying to work with it. To much black and your gun looks like it went through a house fire.

  Hungry Horse
Very little slathering goes on with bone black. It's probably the  least offensive of the ageing materials.
Logged
NEW WEBSITE! www.mikebrooksflintlocks.com
Say, any of you boys smithies? Or, if not smithies per se, were you otherwise trained in the metallurgic arts before straitened circumstances forced you into a life of aimless wanderin'?
Pages: [1]   Go Up
« previous next »