« previous next »
Pages: [1]   Go Down

Author Topic: Pfhel v gouge  (Read 1328 times)

Offline hortonstn

  • Hero Member
  • *****
  • Posts: 653
Pfhel v gouge
« on: March 05, 2021, 03:04:53 AM »
Wanting to purchase a number 2 vee  gouge (width) for incised carving can not figure out pfhel
Number system any one got a part number from woodcraft?
Logged

Offline Stophel

  • Hero Member
  • *****
  • Posts: 4532
  • Chris Immel
Re: Pfhel v gouge
« Reply #1 on: March 05, 2021, 04:18:53 AM »
Well, I went out to look for mine so I could tell you what it was... and can't find the dat burned thing.  Not surprising, considering the current state of my shop and tools and everything else.  It is my #1 tool, and I do just about everything with it... or I did, anyway....  It's around somewhere, but maybe I need to order another one, myself!  I'll see if I can figure out which one it was...  I'm thinking it was a #12 sweep, 6mm wide (close to a quarter inch wide).... maybe a 4....
« Last Edit: March 05, 2021, 04:42:07 AM by Stophel »
Logged
When a reenactor says "They didn't write everything down"   what that really means is: "I'm too lazy to look for documentation."

Offline Stophel

  • Hero Member
  • *****
  • Posts: 4532
  • Chris Immel
Re: Pfhel v gouge
« Reply #2 on: March 05, 2021, 04:47:25 AM »
I'm looking at this one now, and it looks about right.

https://www.rockler.com/flexcut-mc245-45-deg-x-3-16-fixed-handle-mallet-v-tool
Logged
When a reenactor says "They didn't write everything down"   what that really means is: "I'm too lazy to look for documentation."

Offline Ed Wenger

  • Global Moderator
  • Hero Member
  • *
  • Posts: 2457
Re: Pfhel v gouge
« Reply #3 on: March 05, 2021, 04:56:27 AM »
D 12 /2 is what I use, not sure of the part number.  Best,


        Ed
Logged
Ed Wenger

Offline Stophel

  • Hero Member
  • *****
  • Posts: 4532
  • Chris Immel
Re: Pfhel v gouge
« Reply #4 on: March 05, 2021, 05:07:18 AM »
yay, I found it!  I was wrong on all the sizing!  :P    I have a 15-3.  It's a little bit tighter a "V" shape than the 12.
Logged
When a reenactor says "They didn't write everything down"   what that really means is: "I'm too lazy to look for documentation."

Offline hortonstn

  • Hero Member
  • *****
  • Posts: 653
Re: Pfhel v gouge
« Reply #5 on: March 05, 2021, 05:09:14 AM »
Thanks
Logged

Offline LilysDad

  • Full Member
  • ***
  • Posts: 100
Re: Pfhel v gouge
« Reply #6 on: March 05, 2021, 03:01:00 PM »
Woodcraft has a pretty good chart describing their Pfiel sizes; https://www.woodcraft.com/categories/pfeil
Logged
Pages: [1]   Go Up
« previous next »