« previous next »
Pages: [1]   Go Down

Author Topic: Lock Identification  (Read 1144 times)

Offline msb52

  • Starting Member
  • *
  • Posts: 16
Lock Identification
« on: November 23, 2021, 12:15:57 AM »
Needing help to Identify this lock.

Logged

Offline Mike Brooks

  • Hero Member
  • *****
  • Posts: 13235
    • Mike Brooks Gunmaker
Re: Lock Identification
« Reply #1 on: November 23, 2021, 12:35:26 AM »
Appears to be a percussion lock.
Logged
NEW WEBSITE! www.mikebrooksflintlocks.com
Say, any of you boys smithies? Or, if not smithies per se, were you otherwise trained in the metallurgic arts before straitened circumstances forced you into a life of aimless wanderin'?

Offline Feltwad

  • Hero Member
  • *****
  • Posts: 885
Re: Lock Identification
« Reply #2 on: November 23, 2021, 12:46:08 AM »
Looks like a standard repro percussion lock
Feltwad
Logged

Offline Steve Collward

  • Sr. Member
  • ****
  • Posts: 279
Re: Lock Identification
« Reply #3 on: November 23, 2021, 12:50:52 AM »
Could you provided a photo of the other side?
Logged

Offline Bob Roller

  • Hero Member
  • *****
  • Posts: 9335
Re: Lock Identification
« Reply #4 on: November 23, 2021, 01:07:49 AM »
It is a good representation of many locks seen on generic American muzzle loaders.A gunmakers lock.
I recently cobbled one together from left over bits and pieces for a friend and it was very similar to the
one seen on the Archie Peterson J&S Hawken seen in Bob Woodfill's Hawken book.50 years ago I made one
for Tom Dawson.My recent one has a better bridle with one screw and a pin to stabilize it.
Bob Roller
Logged

Offline D. Buck Stopshere

  • Full Member
  • ***
  • Posts: 141
Re: Lock Identification
« Reply #5 on: December 07, 2021, 08:36:45 PM »
For better details on a lock or a firearm, take the photo outside on an overcast day with no sun. It will greatly help with identification, especially this one.
Logged
I'd give my right arm to be ambidextrous.

NMLRA Field Rep- North Carolina
Pages: [1]   Go Up
« previous next »