General discussion > Gun Building
Filling a casting void using brass colored solder
(1/1)
KShatwell:
I have a casting of a coffin lid Patchbox with a fairly deep void on the top edge of the lid . It is too deep to file out so my thought was brass colored solder. Has anyone used this successfully and if so how was the color match?
Mike Brooks:
I've seen old pieces with voids filled with just plain solder and you can also solder in brass patches. It all works.
Frozen Run:
--- Quote from: Mike Brooks on March 26, 2024, 06:09:51 AM ---I've seen old pieces with voids filled with just plain solder
--- End quote ---
Do you need to clean up and prep the area, similar to how a dentist drills out a cavity, prior to filling with solder? Or do you heat up the part and let the solder flow into the rough void? Thank you.
Mike Brooks:
Clean it up and Flux it first.
davec2:
This old post of mine might be a help....as Mike says, clean and flux the $#*! out of the void before you use any solder....
https://americanlongrifles.org/forum/index.php?topic=24222.msg232336#msg232336
Navigation
[0] Message Index
Go to full version