General discussion > Shop Made Tools

Muzzle Stamp Tool

(1/5) > >>

TDM:
This is not my original idea, and I’m sure a lot of members here have used some variation of it. But it might be helpful to a new builder. It’s simple to make and works nicely. Used this today on a .36 SMR I’m building. Just use a wooden dowel smaller than the diameter of your bore, apply tape to create a snug bore fit, secure your punch to the dowel with tie raps and maybe a little tape, and mark the center of each flat. Just a firm hit with a small hammer will create the dimple. Any bulging around the dimple can be removed with sandpaper backed on a flat file.

rich pierce:
Clever, and a nice result!

TDM:
Thank you Rich.

Daniel Coats:
Very innovative

TDM:
Thank you Daniel.

Navigation

[0] Message Index

[#] Next page