I have made three separate jigs to aid in the holding and engraving of flintlock cocks and the top flint jaw. The cock holder (vise) is a design based on a hand drawn sketch given to me by Ron Scott as a potential project. I have made a few changes from the original sketch. The jaw jigs are my design for holding the top flint jaw when it is being worked. One is for engraving and the other for cutting teeth on the jaw's flint side. All tools are made of steel except the tooth cutting jaw holder which I made of aluminum. I wanted to have a softer surface to protect the top jaw side when it's being worked. Both flint jaw holders have a piece of brass attached to the front of the jig with screws to keep the jaw from twisting. The brass has an approximate .050" slit cut into it where the front of the jaw fits. The vise and jaw jigs will work with most common flintlocks. They are NOT going to work with all.
Cock vise
Cock vise held in a vise
Flint side of the tooth cutting jaw jig held in a vise
Top jaw being held for engraving in a vise
These jigs will be made when ordered.
The cock vise is $75.00
Top Jaw engraving jig $35.00
Top jaw Tooth jig $40.00
Shipping for vise with or without jaw jigs is $10.00
Shipping for one jaw jig is $5.00
Shipping for two jaw jigs is $10.00
All three pieces are $135.00 shipped
PM me if you have interest.
Thanks for your time Robert Boggs
