« previous next »
Pages: [1]   Go Down

Author Topic: Old horn repair  (Read 938 times)

Offline loiblb

  • Starting Member
  • *
  • Posts: 31
Old horn repair
« on: November 25, 2023, 09:45:47 PM »
This horn had been used for some time. It was bored with too large a hole in the spout and had no stopper. I counter bored and installed a new buffalo horn spout.
Turned a ebony stopper and three section hard wood base and knob and added some engraving.






Logged

Offline Jeff Murray

  • Hero Member
  • *****
  • Posts: 624
Re: Old horn repair
« Reply #1 on: November 27, 2023, 12:28:07 AM »
nice upgrade
Logged

Offline Tim Crosby

  • Administrator
  • Hero Member
  • *
  • Posts: 18385
  • AKA TimBuckII
Re: Old horn repair
« Reply #2 on: November 27, 2023, 07:10:44 PM »
 Nice job.

   Tim C.
Logged

Offline Daryl

  • Hero Member
  • *****
  • Posts: 15822
Re: Old horn repair
« Reply #3 on: November 27, 2023, 09:52:33 PM »
Sure is a nice job. This one I bought at Dixon's so long ago, needed a new spout, so I turned one out of rosewood.
This is my 2F horn. It 'carries' 1 1/2 pounds of powder.

Logged
Daryl

"a gun without hammers is like a spaniel without ears" King George V

Offline TDM

  • Hero Member
  • *****
  • Posts: 603
Re: Old horn repair
« Reply #4 on: November 28, 2023, 08:21:41 AM »
Good fix.
Logged
Pages: [1]   Go Up
« previous next »