« previous next »
Pages: [1]   Go Down

Author Topic: Horn Shaping Cones  (Read 4852 times)

TENdriver

  • Guest
Horn Shaping Cones
« on: October 04, 2008, 06:41:49 PM »
Should horn shaping cones be sealed with a finish or left raw? 

I sprayed them with poly and then realized they're going to be exposed to heat as well as moisture.  I don't think I'd want the poly to melt all over the inside of the horn.

Kevin H



Logged

Offline Larry Pletcher

  • Hero Member
  • *****
  • Posts: 1748
    • Black Powder Mag
Re: Horn Shaping Cones
« Reply #1 on: October 04, 2008, 06:47:33 PM »
Mine are raw
Logged
Regards,
Pletch
blackpowdermag@gmail.com

He is no fool who gives up what he cannot keep to gain what can never be taken away.

Kayla Mueller - I didn't come here of my own accord, and I can't leave that way.  Whoever brought me here, will have to take me home.

Offline Randy Hedden

  • Hero Member
  • *****
  • Posts: 2250
  • American Mountain Men #1393
Re: Horn Shaping Cones
« Reply #2 on: October 05, 2008, 02:17:57 AM »
Kevin,

All my shaping cones are made of hardwood,  maple or ash, that is unfinished. I have used them for a lot of horns and they seem to last for a very long time.

Randy Hedden

www.harddogrifles.com
Logged
American Mountain Men #1393

Offline James Rogers

  • Hero Member
  • *****
  • Posts: 3163
  • James Rogers
    • Fowling Piece
Re: Horn Shaping Cones
« Reply #3 on: October 05, 2008, 03:47:38 AM »
Mine are unfinished maple
Logged

Daryl

  • Guest
Re: Horn Shaping Cones
« Reply #4 on: October 05, 2008, 03:46:31 PM »
There are several horn shaping threads below.
Logged

TENdriver

  • Guest
Re: Horn Shaping Cones
« Reply #5 on: October 06, 2008, 01:13:29 AM »
I think the Sibley book mentioned using pine so that's what I made mine from.  I'll have to find some reasonable priced hardwood to make a new set. 
Logged

Offline Randy Hedden

  • Hero Member
  • *****
  • Posts: 2250
  • American Mountain Men #1393
Re: Horn Shaping Cones
« Reply #6 on: October 06, 2008, 03:16:52 AM »
Quote from: TENdriver on October 06, 2008, 01:13:29 AM
I think the Sibley book mentioned using pine so that's what I made mine from.  I'll have to find some reasonable priced hardwood to make a new set. 

If you are only making a few horns the pine shaping cones should work okay. I would just use them and see how long they last. I only use hardwood for my shaping cones because I always have lots of maple and ash laying around the shop. If I was going to make them out of pine I would have to go buy some.

Randy Hedden

www.harddogrifles.com
Logged
American Mountain Men #1393
Pages: [1]   Go Up
« previous next »