« previous next »
Pages: [1]   Go Down

Author Topic: Anyone tried Brownell's non-scaling compound ?  (Read 2200 times)

Offline Rolf

  • Hero Member
  • *****
  • Posts: 1766
  • There's more than one way to skin a cat.
Anyone tried Brownell's non-scaling compound ?
« on: October 21, 2011, 08:34:50 PM »
This sounds like a good product to use when hardening frizzens and springs cast in carbon steel.  As anyone tried it?
http://www.brownells.com/.aspx/pid=1122/Product/NON-SCALING-COMPOUND

Best regards

Rolf
Logged

Offline B. Hey

  • Sr. Member
  • ****
  • Posts: 290
Re: Anyone tried Brownell's non-scaling compound ?
« Reply #1 on: October 22, 2011, 05:59:13 AM »
Rolf, I've used it a few times with relative success. That being said, I in no way consider myself a "smithy". The pieces I used it on were indeed easy to clean after heat treating. Hopefully others will have more comment for you. Take care .. Bill
Logged
Pages: [1]   Go Up
« previous next »