« previous next »
Pages: [1]   Go Down

Author Topic: Matching touch hole liner to barrel size?  (Read 2205 times)

Offline draken

  • Sr. Member
  • ****
  • Posts: 404
Matching touch hole liner to barrel size?
« on: May 28, 2016, 10:21:16 PM »
Just out of curiosity, is there a rule of thumb as to what size White Lightning liner recommended for say; A, B or C weight barrels?   
Logged
Dick 

Times have sure changed. Gun control used to mean keeping the muzzle pointed in a safe direction

Never write a check with your mouth that your butt can't cash!

Offline wattlebuster

  • Hero Member
  • *****
  • Posts: 2088
Re: Matching touch hole liner to barrel size?
« Reply #1 on: May 28, 2016, 10:25:34 PM »
I always use the 1/4 inch an that way if I mess something up (which I have done before) or I every shoot it enough so it needs to be changed then you can go up in size ;D
Logged
Nothing beats the feel of a handmade southern iron mounted flintlock on a cold frosty morning

Boompa

  • Guest
Re: Matching touch hole liner to barrel size?
« Reply #2 on: May 28, 2016, 11:54:37 PM »
  Same here on using 1/4".  There is no difference in the performance of the different sizes as far as I know and the 1/4"er gives me a lot more wiggle room  It allows for a slightly skinnier lock area.
Logged

Offline flehto

  • Hero Member
  • *****
  • Posts: 3335
Re: Matching touch hole liner to barrel size?
« Reply #3 on: May 29, 2016, 12:00:20 AM »
I also use the 1/4" because it allows for more leeway when positioning the TH. Because the lock on a Bucks County is positioned high as w/ a Lehigh, the 1/4" works perfectly. Haven't screwed up an installation as yet, but the !/4" would give a second chance. The BC LR below has the  1/4"  White Lightning just missing the corner of the flat.....Fred

 
« Last Edit: May 29, 2016, 12:01:36 AM by flehto »
Logged

Offline Mike Brooks

  • Hero Member
  • *****
  • Posts: 13415
    • Mike Brooks Gunmaker
Re: Matching touch hole liner to barrel size?
« Reply #4 on: May 29, 2016, 12:03:52 AM »
Well, I guess I'm odd. (who would a thunk it?) I use 5/16". I go with the 3/8" for 10's 11's and 12 bores.
Logged
NEW WEBSITE! www.mikebrooksflintlocks.com
Say, any of you boys smithies? Or, if not smithies per se, were you otherwise trained in the metallurgic arts before straitened circumstances forced you into a life of aimless wanderin'?

Offline wattlebuster

  • Hero Member
  • *****
  • Posts: 2088
Re: Matching touch hole liner to barrel size?
« Reply #5 on: May 29, 2016, 02:03:09 AM »
If I had put in as many as you Mike then I could start with a 5/16
Logged
Nothing beats the feel of a handmade southern iron mounted flintlock on a cold frosty morning

Offline Mark Elliott

  • Hero Member
  • *****
  • Posts: 5191
    • Mark Elliott Artist & Craftsman
Re: Matching touch hole liner to barrel size?
« Reply #6 on: May 29, 2016, 02:57:17 AM »
Whatever fits within the flats of the barrel.   Mostly,  I use 5/16".
Logged
Pages: [1]   Go Up
« previous next »