« previous next »
Pages: [1]   Go Down

Author Topic: rifle hardware  (Read 1489 times)

Offline little joe

  • Hero Member
  • *****
  • Posts: 685
rifle hardware
« on: January 08, 2017, 12:39:21 AM »
Were southern rifles ever trimed in a mix of brass and iron as they were conservative and didn,t want to waste anything and used what on hand?
Logged

Offline Mike Brooks

  • Hero Member
  • *****
  • Posts: 13415
    • Mike Brooks Gunmaker
Re: rifle hardware
« Reply #1 on: January 08, 2017, 12:48:14 AM »
Yep, get Dennis Glazener's book on the Gillespies.
Logged
NEW WEBSITE! www.mikebrooksflintlocks.com
Say, any of you boys smithies? Or, if not smithies per se, were you otherwise trained in the metallurgic arts before straitened circumstances forced you into a life of aimless wanderin'?

Offline David R. Pennington

  • Hero Member
  • *****
  • Posts: 2928
Re: rifle hardware
« Reply #2 on: January 08, 2017, 06:38:13 AM »
My first build was patterned after an original rifle a distant relative of mine owned from southern WV. It had brass trigger guard and butt plate, pierced brass side plate and iron nosecap. The thimbles were iron except the center thimble was brass.
Logged
VITA BREVIS- ARS LONGA
Pages: [1]   Go Up
« previous next »