Author Topic: What does your napping tool for your flintlock look like?  (Read 10706 times)

Offline Pukka Bundook

  • Hero Member
  • *****
  • Posts: 3410
Re: What does your napping tool for your flintlock look like?
« Reply #50 on: March 24, 2020, 05:32:59 AM »
Mine looks like a flat, one-piece metal turnscrew, because it is.  Takes up no room at all and has always worked.

Offline Bob McBride

  • Hero Member
  • *****
  • Posts: 2840
  • TENNESSEE
    • Black Powder TV
Re: What does your napping tool for your flintlock look like?
« Reply #51 on: March 24, 2020, 06:53:00 PM »
Thinking through this a bit, as folks have mentioned, I most often need to nap with the firearm loaded, and I’d imagine most napping was done historically with an iron hammer, turn screw or knife blade, I can see another important reason for feather holes or tapered vent picks....
« Last Edit: March 24, 2020, 06:57:14 PM by Bob McBride »

Offline MuskratMike

  • Hero Member
  • *****
  • Posts: 2248
Re: What does your napping tool for your flintlock look like?
« Reply #52 on: March 24, 2020, 07:03:10 PM »
Feather holes, now where did I see a video recently about this? I try and get the 'ol girl to fire by wiping flint and frizzen with alcohol. Then after it has fired I clean up the flint with a brass tool, but that's just me.
"Muskrat" Mike McGuire
Keep your eyes on the skyline, your flint sharp and powder dry.

Offline Bob McBride

  • Hero Member
  • *****
  • Posts: 2840
  • TENNESSEE
    • Black Powder TV
Re: What does your napping tool for your flintlock look like?
« Reply #53 on: March 24, 2020, 07:05:08 PM »
Feather holes, now where did I see a video recently about this? I try and get the 'ol girl to fire by wiping flint and frizzen with alcohol. Then after it has fired I clean up the flint with a brass tool, but that's just me.

 :)

Offline Daryl

  • Hero Member
  • *****
  • Posts: 15662
Re: What does your napping tool for your flintlock look like?
« Reply #54 on: March 24, 2020, 09:38:42 PM »
2 different napping tools I use.

The second one also works well and is used in a prying motion.
The base of your frizzen on English flints by lining it up on the edge of the flint and pushing down.




Daryl

"a gun without hammers is like a spaniel without ears" King George V

Offline DBoone

  • Full Member
  • ***
  • Posts: 197
Re: What does your napping tool for your flintlock look like?
« Reply #55 on: April 02, 2020, 05:39:06 PM »
I shoot frontier style all the time out of my pouch and do not even own a ball starter.  I carry the bare minimum.

To nap a flint I go to half cock, put my LH index finger under the flint edge to support it and use the back of my belt knife to tap the flint's edge.  Takes a little practice but works great.