« previous next »
Pages: [1]   Go Down

Author Topic: Some Progress on "Back At It Pistol"  (Read 1168 times)

Offline Tim Crosby

  • Administrator
  • Hero Member
  • *
  • Posts: 18385
  • AKA TimBuckII
Some Progress on "Back At It Pistol"
« on: October 04, 2020, 11:45:10 PM »
 The original thread:

  https://americanlongrifles.org/forum/index.php?topic=62015.msg621899#msg621899

 
 Got the barrel in, two lugs the pins just touch the barrel. RR hole drilled, tapered the 5/16th rod to 1/4 (.40cal) so it would miss the main spring and slim things down. Wasn't going to use a cap but the web is almost nonexistent so I figured it would help hold things together. The thimble is one piece with a cut out, haven't decided on an entry pipe, may be just a entry plate or may not have one. Washers holding the lock nail, haven't decided on a plate or washer. The guard is a cut down Gillespie that will house set triggers. Lots of wood to come off.

  Tim C.
 



Logged

Offline Curtis

  • Hero Member
  • *****
  • Posts: 2338
  • Missouri
Re: Some Progress on "Back At It Pistol"
« Reply #1 on: October 05, 2020, 07:32:27 AM »
You are off to a great start Tim, keep the posts coming!

Curtis
Logged
Curtis Allinson
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
Sometimes, late at night when I am alone in the inner sanctum of my workshop and no one else can see, I sand things using only my fingers for backing

Offline Bob Roller

  • Hero Member
  • *****
  • Posts: 9687
Re: Some Progress on "Back At It Pistol"
« Reply #2 on: October 05, 2020, 04:12:58 PM »
It may not be possible to use a double set trigger on this project.
I've been running the cursor of this laptop and know where the sear
is on this lock but will know for sure when I see the drawing that MIGHT
get here today.
Bob Roller
Logged

Offline Tim Crosby

  • Administrator
  • Hero Member
  • *
  • Posts: 18385
  • AKA TimBuckII
Re: Some Progress on "Back At It Pistol"
« Reply #3 on: October 05, 2020, 04:23:17 PM »
Quote from: Bob Roller on October 05, 2020, 04:12:58 PM
It may not be possible to use a double set trigger on this project.
I've been running the cursor of this laptop and know where the sear
is on this lock but will know for sure when I see the drawing that MIGHT
get here today.
Bob Roller

  Thanks for at least taking a look at it Bob. It should be there today I would hope.

   Tim
Logged
Pages: [1]   Go Up
« previous next »