« previous next »
Pages: 1 ... 3 4 [5]   Go Down

Author Topic: New .36 cal Rifle....All the patch box parts are made....next task - inlet it  (Read 11639 times)

Offline Daryl

  • Hero Member
  • *****
  • Posts: 15822
Re: New .36 cal Rifle....Another brass patchbox part
« Reply #100 on: November 18, 2024, 09:51:56 PM »
OVER THE TOP, Dave, over the top. WOW!
Logged
Daryl

"a gun without hammers is like a spaniel without ears" King George V

Offline davec2

  • Hero Member
  • *****
  • Posts: 2955
    • The Lucky Bag
Re: New .36 cal Rifle....All the patch box parts are made....next is to inlet it
« Reply #101 on: November 21, 2024, 10:42:49 PM »
Finished the assembly of the door / hinge / finial of the patch box.  Finished shaping the finial after cutting it out.  Then burnt off the pattern and annealed the brass.  By hand bending and the use of a small rubber hammer, I contoured the finial roughly to the stock shape.  Filed the second half of the hinge to fit the curve of the finial plate and then hard soldered the hinge half in place.  With all the parts made, I can start the inletting of the box......always fun !











Logged
"No man will be a sailor who has contrivance enough to get himself into a jail; for being in a ship is being in a jail, with the chance of being drowned... a man in a jail has more room, better food, and commonly better company."
Dr. Samuel Johnson, 1780
Pages: 1 ... 3 4 [5]   Go Up
« previous next »