Author Topic: Barrel bender/straightener fixture  (Read 817 times)

Offline David Rase

  • Hero Member
  • *****
  • Posts: 4323
  • If we need it here, make it here. Charlie Daniels
Barrel bender/straightener fixture
« on: November 11, 2024, 09:25:30 PM »
After straightening/bending barrels on my steel bench using aluminum blocks and a C-clamp, I decided to make myself a real press for bending barrels.  The frame is made from 1 1/2" square tubing with a .250" wall thickness.  1/2" bolts hold the 1/8" x 2" plates to the tubing.  1/2" threaded rod applies the pressure through a Delrin block which will keep the fixture from damaging the barrel.  I think this fixture will do the job.



Offline Ky-Flinter

  • Global Moderator
  • Hero Member
  • *
  • Posts: 7505
  • Born in Kentucke, just 250 years late
Re: Barrel bender/straightener fixture
« Reply #1 on: November 12, 2024, 06:53:47 AM »
As always, very nice work David.

Ron
Ron Winfield

Life is too short to hunt with an ugly gun. -Nate McKenzie

Offline J Shingler

  • Full Member
  • ***
  • Posts: 196
Re: Barrel bender/straightener fixture
« Reply #2 on: November 12, 2024, 05:41:13 PM »
That should get the job done! As always Dave. Well thought out. I like the dial indicator as well. I have used feeler gauges but I believe your way would be much faster as I have to take the barrel out and lay it on a straight edge each time.
Jeff
Thank you
Jeff

Offline Austin

  • Hero Member
  • *****
  • Posts: 502
  • Austin Paul
Re: Barrel bender/straightener fixture
« Reply #3 on: November 13, 2024, 02:15:19 AM »
So David….
We shouldn’t be using the fork of a tree??
Eat Beef

Offline Stoner creek

  • Hero Member
  • *****
  • Posts: 2916
Re: Barrel bender/straightener fixture
« Reply #4 on: November 13, 2024, 02:22:04 AM »
Way too scientific for this old redneck!🤪
Stop Marxism in America

Offline john bohan

  • Sr. Member
  • ****
  • Posts: 341
Re: Barrel bender/straightener fixture
« Reply #5 on: November 13, 2024, 03:55:51 AM »
I hope I never need one.