« previous next »
Pages: [1]   Go Down

Author Topic: Assembly bench up-date  (Read 5035 times)

Offline P.W.Berkuta

  • Hero Member
  • *****
  • Posts: 2213
Assembly bench up-date
« on: January 17, 2010, 11:53:40 PM »
I have been slowly updating my assembly bench and I have a few more mod's to go but it is serving me well so far. Also a little chisel use tip - to help control the depth of cut stamp-in some perpendicular stop cuts along the inleted part - helps prevent excessive tear-out and helps regulate depth - but you already knew that -



« Last Edit: January 14, 2020, 05:09:41 AM by rich pierce »
Logged
"The person who says it cannot be done should not interrupt the person who is doing it." - Chinese proverb
Pages: [1]   Go Up
« previous next »