« previous next »
Pages: [1]   Go Down

Author Topic: Sight Drift  (Read 2412 times)

Offline TDM

  • Hero Member
  • *****
  • Posts: 603
Sight Drift
« on: March 09, 2023, 10:42:55 PM »
This is an adaptation that I stumbled upon sometime back, thought some might find it useful. I use a 3/8” brass rod, cut to about 4 1/2” in length. Using a flat mill file, I taper the rod and form an undercut ledge at the tip. This ledge will rest over the edge of the sight base and stabilizes the drift while tapping the sight into the dovetail. Also great for sight adjustments. I’ve made several of these, and they work well.

Logged

Offline MJBush

  • Jr. Member
  • **
  • Posts: 81
Re: Sight Drift
« Reply #1 on: March 11, 2023, 10:51:39 PM »
Looks good. Thanks for the post. I am going to make one.
Michael
Logged

Offline B.Habermehl

  • Hero Member
  • *****
  • Posts: 1689
Re: Sight Drift
« Reply #2 on: March 12, 2023, 05:55:30 PM »
Nice deal. Gotta watch brass can work harden an actually become as hard as steel. I’ve deformed steel with brass before. I normally drift sights with a hickory punch. Metal punches are a last resort for me. Lots of ramrod scraps to make punches out of in my shop. BJH
Logged
BJH

Offline TDM

  • Hero Member
  • *****
  • Posts: 603
Re: Sight Drift
« Reply #3 on: March 13, 2023, 06:49:30 AM »
Quote from: MJBush on March 11, 2023, 10:51:39 PM
Looks good. Thanks for the post. I am going to make one.
Michael

I think you’ll be pleased with the ease of use. It’s a useful tool.
Logged
Pages: [1]   Go Up
« previous next »