« previous next »
Pages: [1]   Go Down

Author Topic: How to cut these  (Read 732 times)

Offline foresterdj

  • Sr. Member
  • ****
  • Posts: 372
How to cut these
« on: January 19, 2026, 01:31:38 AM »
The jaeger I am working on will have these fancy cast metal pieces on the sliding patch box lid. I am a long way from working on that part yet, but every time I look at them I wonder how I can most easily cut off the casting sprues.







Logged

Offline JPK

  • Sr. Member
  • ****
  • Posts: 427
Re: How to cut these
« Reply #1 on: January 19, 2026, 02:21:59 AM »
Epoxy  them to a board, then when done a bit of heat will release them.
Logged
A clear conscience is usually the sign of a bad memory.

Offline wogden

  • Jr. Member
  • **
  • Posts: 62
Re: How to cut these
« Reply #2 on: January 19, 2026, 02:34:32 AM »
Don’t cut all of the spruce off.  You need a bit to drill an hole thru for pins to retain brass piece to wood.  Suggest B you call/discuss with Ron Scott.









Logged
Warren Ogden

Offline Jakob

  • Sr. Member
  • ****
  • Posts: 423
Re: How to cut these
« Reply #3 on: January 21, 2026, 08:07:55 PM »
Quote from: wogden on January 19, 2026, 02:34:32 AM
Don’t cut all of the spruce off.  You need a bit to drill an hole thru for pins to retain brass piece to wood.  Suggest B you call/discuss with Ron Scott.










That sure is some piece of wood and very nice carving!.
Logged

Offline dadybear1

  • Full Member
  • ***
  • Posts: 199
Re: How to cut these
« Reply #4 on: January 22, 2026, 12:03:12 AM »
X 2 JAKOB--
Logged

Offline Pete G.

  • Hero Member
  • *****
  • Posts: 2016
Re: How to cut these
« Reply #5 on: January 22, 2026, 02:45:46 AM »
WOW! These pics make me glad that I’ve never been attracted to Jaegers.
Logged
Pages: [1]   Go Up
« previous next »